Ridetech 11306699 User Manual download pdf

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11306699

67-70 Impala Rear Upper StrongArm & Panhard Bar Kit

Upper Arm Components:

1 90001117 Upper StrongArm – C-C 10.00”

1 90001589 Kevlar lined Heim end - .75” thread x .625” I.D.

1 99752004 3/4”-16 SAE jam nut

2 90002066 Aluminum bearing spacer

1 90001085 Poly busing half

1 90001089 Poly busing half

1 90000722 Inner bushing sleeve - 2.625" long x .625" I.D x .75" O.D.

Panhard Bar Components:

1 90000998 Panhard bar – TW 33.875” (C-C 35.75”)

1 90001942 Rubber bushing – Pressed into panhard bar

1 90001946 Kevlar lined Heim end - .75” thread x .75” I.D.

1 99752004 3/4”-16 SAE jam nut

2 90000724 Aluminum T-bushing

1 90000461 Panhard bar axle stud

Hardware:

2 99621006 5/8” x 3 ¾” SAE Gr. 8 bolt Upper arm

3 99622006 5/8” SAE Nylok jam nut Upper arm / panhard bar stud

1 99561003 9/16” x 3” SAE Gr. 8 bolt Panhard bar to frame

2 99562001 9/16” SAE Nylok jam nut Panhard bar

1 99563001 9/16” USS flat washer Panhard bar stud

1 99603003 5/8” USS flat washer Panhard bar stud

1 2 3

350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11306699 67-70 Impala Rear Upper StrongArm &

Installation Instuctions 1. Replace the factory upper trailing arm with the StrongArms. 5/8” x 3 ¾” bolts and Nylok jam nuts are supplied t

Page 3

11. The Heim end will attach to the frame using the 9/16” x 3” bolt and Nylok nut. Two aluminum T-bushings need to be installed on each side o

No comments

Ridetech 11306699 User Manual